黄道平面与Ecliptic projector(小知识)

John

原帖由 HammerSun 于 2007/1/22 17:20 发表


这个牛B的啊，详细介绍下呢。

没用过吗?ccb说效果不是很好.

原帖地址

Title: Xai Corp. Navigation Override System Mk1 (NOS)
Version: 1.2
Description: Overrides the autopilot to avoid dangerous situations

This script is for those traders amongst us, who prefer a more peacefull existance to the fighter jocks, and will hopefully make your transports less prone to being caught in firefights.

The command requires the Ecliptic Projector to be fitted on any ship you wish to use the command on.

Quote:
In an increasingly hostile universe the simplistic remote commands for ship are getting ships needlessly destroyed. In an attempt to correct for this problem, and provide for some danger awareness in automated ships, Xai Corporation has devised a system that can be plugged into any ship and provide an automated response to possible dangers.

The NOS runs on an Auxiliary Command Slot and monitors the ship's scanners. If hostile ships are detected it will take action to avoid the danger. The actions range from steering wide of the danger to docking at the nearest station if it believes it is in immediate danger.


Feedback into how well this functions and whether any changes to the behavior are needed are much appreciated.

HammerSun

偶很少用脚本，只用了4个而已。

HammerSun

刚跑题了，现在回家截图一张，借楼主谈起黄道面的机会，帮助新人建立下X3中的空间概念。


先说明一下，我飞船下方的是Z轴的负数端，我在平面上方。
那么，对应坐标里的x,y,z
轴左边的为x负数，右边x为正数
平面上方y为正数，下方为y负数
我的位置到中心点z为负数，再继续向前z就是正数了。

好像有点白，很简单啦:L
希望还是有那么一点点帮助。


[ 本帖最后由 HammerSun 于 2007-1-22 19:28 编辑 ]

freeman00

原帖由 ccb 于 2007-1-22 16:04 发表
学习了 ... 不过以后盖工厂还是到处乱放,即便不是沿着黄道平面的话想排齐INSERT也够了呀:lol

当然，通过inster可以确认上下左右对齐，不过仍旧需要通过小键盘的1、3、7、9来旋转工厂。如果再能熟悉各个工厂连接点的位置，就可以让那些疯狂的管子变的有条理。:lol